Guide :Exercise & Fitness : XP Weight Loss 620 Treadmill

Treadmill control panel not functioning properly

I own a Pro-Form 540 Treadmill which is now out of warrenty and the electronic keypad control panel is not functioning properly. Sometimes I can't turn the machine on at all and at other times one or two of the many keypad functions will be responsive. I suspect there might be a fairly simple solution to this problem and would like to explore this possibilty before spending the $500 or so that the company says it will cost to replace the entire control panel. Thanks for your help.

Research, Knowledge and Information :

3 Easy Ways to Fix a Treadmill (with Pictures) - wikiHow

How to Fix a Treadmill. ... If your treadmill speed control is a digital display/button that you press to speed ... Never use a treadmill that is not working properly.
Read More At :

The Controls Are Not Working on a NordicTrack Treadmill ...

May 31, 2015 · Incline Control Not Working Correctly. If the treadmill doesn't seem to respond properly when you change the incline, you may have to calibrate the machine.
Read More At :

My proform treadmills console buttons are not working properly.

My proform treadmills console buttons are not ... are not working properly. When I turn the treadmill on the lights ... from the keypads to the control ...
Read More At :

Treadmill Troubleshooting: Treadmill Console Broken - YouTube

Sep 09, 2013 · Is your treadmill keypad broken or treadmill keypad not working? ... Treadmill Troubleshooting: Treadmill ... Troubleshooting a Treadmill Control Panel ...

Panel Dims - Best Treadmill | Treadmill Doctor

My control panel dims ... If your treadmill uses ... make sure the disk that passes inside the sensor or the strobe disk is clean and aligned properly. If not ...
Read More At :

pdf of the F63 owner's manual - Sole Fitness Equipment

OPERATING YOUR NEW TREADMILL! OWNER’S MANUAL ... If you feel the buttons are not functioning properly with normal pressure ... Getting familiar with the control panel
Read More At :

RunningAHEAD - Topic: NordicTrack treadmill issue

Forums >Gears and Wears> NordicTrack treadmill ... that the place you are plugging the treadmill in is properly grounded and not faulty ... is not working.
Read More At :

How to Fix Common Treadmill Problems 2017 |

How to Fix Common Treadmill ... Non-Working Motor. Fixing a non-working treadmill motor can be one of the more ... cause the belt to heat up and not run properly.
Read More At :

Electrical Problems - Treadmill Doctor - Treadmill | Treadmills

Electrical Problems; ... My treadmill has no power. My control panel dims or ... everything that you will need to do the job properly. When you're a Treadmill Doctor ...
Read More At :

Suggested Questions And Answer :

Treadmill control panel not functioning properly

Hi Pstefanski..Afraid there is no easy fix to this problem..I had the same also..I called Sears and for the cost of replacing the keyboard, it would be cheaper to buy a new treadmill..keyboard was close to $300 ..depend how old it is to tellu the truth..AL
Read More At : XP Weight Loss 620 Treadmill...

The +/- speed buttons and the red stop button do not function

Sounds like the function keypad has failed or worn out from excessive use of those buttons Call Kettler's customer support KETTLER International Inc.P.O. Box 2747Virginia Beach, VA 23450 USA Tel (757)427-2400 Fax (757)427-0183 Email [email protected] or
Read More At : TX1 Treadmill with FREE INSIDE Delivery! Treadmill...

Front console not working

Try this first: 1) Replace the batteries by new ones, clean the contacts batteries very well with c. cleaners. 2) adjust the REED swtich, test for open or faulty, clean it, and tigh the connector very well.3) tight the ribbon cables inside, clean it, and tight very w.4) see the diagram attached and try again.God bless you
Read More At : NordicTrack T7 si Treadmill...

I have a proform xp 620 treadmill and the control panel keeps shutting off and on. i can start walking then it shuts off and then seconds later it comes back on

Adjust the sensor switch first.2) change the batteries if have it.3)tight the flexible cable vs display board.4) tight the connector from display board vs lower board.If the problem must test the following:1) Test the main motor.2) See if the drive belt is broken, loose, or slip3)finally the main motor board possible is faultysee block diagramgood luck.sincerely.e.cuadramanagua,nicaragua
Read More At : XP Weight Loss 620 Treadmill...

Hi, i own a proform xp 615 treadmill and it is stuck in a continous incline mode (as in it just keeps going up and down slowly but the panel controls won't work) and you can't reset it so that you can walk on it, reset button does not help. HELP!!!!!

Sounds like the control board went bad and needs to be replaced. I don't know how long you have had this but is it under warranty still? Even if it isn't, you should call the manufacturer and see what they will do for you and they can provide you with what you need to fix it.Benjamin
Read More At : XP Weight Loss 620 Treadmill...

I have a Epic 400mx and i did not use the mechine for almost 2 years and now few control buttons of the control panel ( start, 1 and 9 mile speed) are working and rest of the control buttons are not working or responding. it is set to manual. By the way motor is working only in 1 or 9 mile speed due to control panel issue and display and fan function is working fine.

Most of these use a membrane keyboard with silver inked conductors on plastic membranes that are pressed together through a hole in an insulation layer between the two printed membranes. When these keyboards start to go bad REPLACEMENT is really the only solution.
Read More At : 400 Mx Treadmill...

Nordictrac 2500 problem: when dead man key is removed, control panel lights up, but none of the functions work. With he key in place the treadmill functions normally.

Hello, You have it in DEMO mode, your manual will show you how to disable this feature. Have a good new year!
Read More At : NordicTrack Treadmill, A2550...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.1006 seconds