Guide :Exercise & Fitness : NordicTrack Treadmill, A2550

Treadmill belt keeps sliding to the left

Ok i bought I used treadmill from a family member and I see the belt had pulled way to the left..Welli got home ajusted and tighten it up and ran on it for about 30 minutes and right back to the left it was again..I centered it a couple times and after about 30 minutes it pulls back to the left.I removed the cover over the motor and everything looks pretty good besides some belt dust but not a lot..Now there is a screeching sound that sounds like its coming from the top roller and the roller looks like it is kinda wobbly a bit when you close one eye and look real good at the edge of the roller

Research, Knowledge and Information :

Why Does My Belt on My Treadmill Keep Sliding to One Side ...

Nov 01, 2015 · Why Does My Belt on My Treadmill Keep Sliding to ... via the left bolt only. With the ProForm treadmill, ... the problem or if it keeps ...
Read More At :

My belt keeps sliding to the right (or left) | CT Treadmill ...

If your treadmill belt keeps sliding to the left (or right) you may have a bigger problem than the rear roller being off of alignment. Look on the inside of the ...
Read More At :

Belt Wont Stay Centered - Treadmill Doctor

My Belt Won't Stay Centered. BELT MOVES TO ONE SIDE AFTER TRACKING Without a person on the treadmill, make sure the belt will run centered at 5 MPH.
Read More At :

How to Align a Treadmill Walking Belt | Sportsmith Blog

How to Align a Treadmill Walking Belt . ... If you find that the belt slides to the left of the roller while the treadmill is ... Why Your Treadmill Belt Maybe Slipping;
Read More At :

How To Fix A Slipping Treadmill Belt - YouTube

Mar 20, 2014 · I show how to repair a treadmill walking belt that slips or stops ... To Fix A Slipping Treadmill Belt ... on a treadmill. Mine was too far to the left.

Center The Walking Belt | ProForm Support

Center The Walking Belt. ... Any adjustments that are going to be made will and should be done on the LEFT side of the treadmill (as shown in the diagram).
Read More At :

treadmill - ShopYourWay

Get shopping advice from experts, friends and the community! my treadmill # 831297231 the belt keeps sliding to the left
Read More At :

Suggested Questions And Answer :

Nordictrack commercial 1600 treadmill drive belt keeps slipping off the front roller.

Hi Brent, I do suggest ringing Icon Fitness and let them organize a tech to look at the machine.
Read More At : Nordic Track...

My weslo cadence 200 treadmill belt keeps slipping to the left. i keep tightening and loosing it to keep it even but i keeps sliding to the left

Please look under the bottom of the treadmill and be sure that your alignment brackets are not benmt/missing. (put the machine in the storage position and look about 2/3 way down the side of the belt) you should see a metal bracket on each side pressing in on the belt. They should be pressing in about 1 1/2 -2 inches to help track the belt.
Read More At : XP Weight Loss 620 Treadmill...

I have a horizon t92 treadmill. my problem is with belt slipping, no matter how many time i center it it keeps moving back to the left side. and now it slides all the way onto the lip of the left side until it jams.

When I turn on I keep getting message lube belt what does it mean and how do I solve problek
Read More At : T92 - Treadmill...

Belt off center on front roller

See the video and proceed according. God bless you
Read More At : NordicTrack A2750 PRO Treadmill...

I have a summit 4500. the belt is off center to the left side and I have use all the adjustment and the belt doesn't move

Good day. The belt can go off track for a number of reasons. If you say you've used all the adjustment and the belt doesn't move. To me this could mean that the belt either doesn't rotate or it is not moving to the center (centre), or to the right. I presume you mean it doesn't return to the center. But since you have said you've used all the adjustments, that also means that you have actually removed the plastic guards off to have done the supposed adjustments needed to make the belt track back in the center. So, here is the confusing part. Depending on which plastic guards you removed to do the supposed adjustments, normally the belt tracking bolts are at the foot of the treadmill. Stand on the treadmill, looking at the Instrument panel, the foot of the treadmill is behind you. There are two hex type adjusting bolts, one on each side. Now if the belt pulls left, you don't tension the left adjusting bolt, which would stretch the belt and make the treadmill labour worse. A belt that pulls sideways now but not when it was new, shows that the treadmill belt had been neglected. Instead, try slackening the right adjusting bolt to loosen the tension of the belt. An over tightened belt makes the motor work harder, leading to overheating and cook out, plus it also stretches the belt unnecessarily. A lose belt also means it slips at the revolving rotor (motor side) each time you impact the belt with your feet as you run or jog, therefore it means that the slippage will cause the rotor or the belt to wear out. To check on the correct tightness, lift one side of the belt at the center of the platform. It should raise no more that 2 and half inches. if it is less, it is too tight, if it is more, it is too slack. Either way, it is for you to experiments because you could be a six foot five and weight a tonne or you could be a four foot two and weight like a butterfly. Each person is different. Most treadmills are adjusted for up to five foot ten and for those that are taller or bigger, there are treadmills designed for them too. As you know, there are treadmills for all walks of life, small ones, medium ones and large ones, all designed for the appropriate weight ratio in mind. You can't use a small treadmill if you're six foot two and weight 14 stones (90 kg). There are treadmills to accommodate larger people. Most belt failures are the result of... like I said above, a number of reasons. One of them is the failure to maintain a treadmill. Lift the belt and place the palm of your hand on the metal platform (where the belt glides on) and feel if it is sticky, hard to slide the palm of your hand, or feels dry. If any of thei si evident, then your treadmill od labouring and that means the result of the belt running to one side is because it has been stretched as the motor laboriously and continuously been trying to keep going. I have a Stream treadmill and every month of continuous usage, I lubricate the underside of the belt with a quality silicone lubricant, in spray form. I never spray it directly underside, especially if I have carpeted floor, but if you have lino or polished floorboards, I suggest you don't spray it at all because it stains carpets and makes lino and floorboards slippery. Instead, use a lint free cloth. Go outside, spray the lubricant on the cloth to just soak one side, then shape the cloth into a ball, return inside and lift the belt at the center and apply the wet site of the cloth on the platform, not under the belt. Spread the lubricant evenly across the center of the platform but not towards the rollers, just the center. Then run the treadmill a little. Stop it and reapply it again. Repeat the process a third time, then run it again. Then stop it and lift the belt. With the palm of your hand, see if you can feel any moisture or a slippery feel on the platform. If it feels slippery, then the belt is lubricated properly. Do this only every month of daily use. The lubricating of the platform is almost very little. never over lubricate or you'll soon see that excess lubrication stains the machine. You can hear it when the belt runs dry. A belt that is adjusted and lubricated properly runs almost silent, but a dried out belt sounds raspy.
Read More At : NordicTrack Treadmill, A2550...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.1336 seconds