Guide :Exercise & Fitness : Exercise & Fitness

Error codes cyclone sx9.0 max pro tread mill has ''err 1'' on display when you try and start it up, its had very little use, ony about 10 hours in two years, anyone have a user guide or know the error codes??

Posted by carl1968 on Jan 03, 2009

Research, Knowledge and Information :



We did not find results for: error codes cyclone sx9 0 max pro tread mill has err 1 on display when you try and start it up its had very little use ony about 10 hours in two years anyone have a user guide or know the error codes.

Suggested Questions And Answer :


Error codes cyclone sx9.0 max pro tread mill has ''err 1'' on display when you try and start it up, its had very little use, ony about 10 hours in two years, anyone have a user guide or know the error codes??


I get a 51 code on the treadmill, I think the relay is bad, Can I get parts for this? Pat please respond to [email protected]
Read More At : Exercise & Fitness...

Treadclimber error code H-23


Answer from bowflex service line. H 23 means "no tac signal". which means, a signal cable is loose or disconnected. OR the motor needs replacing...estimated cost $350 Canadian.
Read More At : Exercise & Fitness...

Model :ion treadmill 7.9t (bladez ) ,e1 error runs 7 sec and stop


E1 represents a speed sensor error. Remove the cover and the speed sensor is located alongside the top left roller/wheel. this wheel has a metal disk on it's side that the sensor counts each time it passes. Adjust the sensor as close to the metal disk as possible without making physical contact. Roll the wheel several times to ensure there is no contact. It was noticed on ours that the alignment of the sensor is not centered to the metal disk, and was reading the outside edge of the disk. Turn the sensor just a bit to read as musch of the disk as possible.
Read More At : Blaze...

Hyper Extension JN 1360 Error Code 4


If you wish to get some details about treadmill repair and error codes ; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/
Read More At : Exercise & Fitness...

Hi i have a nordictrack commercial model NTL12309.0 the belt slips i tried to tighten it but not too much, I still have around 3 inches of play on the belt. I took the cover off only to find out that the pulley on the roller has moved in and it looks like little ridges under where it use to sit. Now is the pulley pressed on the roller or glued on it, one representative told me it might be glued on. Is that in your opinion a defect or a wear and tear, the machine is two years old and wasnt used so much in the last year and a half, I store it in the basement. I hope i was clear thank you


Please see the video and proceed according with common sense.God bless you
Read More At : Nordic Track...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.fitness-equipment-plus.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1288 seconds